中文
English
(Please be sure to pay attention to the following matters, otherwise the consequences will not be responsible)
1. Check if the voltage is correct before use. Please use the voltage indicated on the machine to avoid electric overload and fire.
2. ※The motor running direction is normal. If there is gas in the air outlet, it is normal. (Applicable only to models with three-phase voltage 380V).
3. When the display temperature is different from the actual temperature (measured by the standard thermometer), the parts and internal parameters of the circuit board should not be adjusted at will. The company should be notified to send the staff to handle.
4. When the temperature changes during use, do not open the door at will.
5. Do not place the machine in a damp place or rinse it directly with water to prevent leakage.
6. It is forbidden to put alcohol or adhesive. . . Etc., flammable, volatile items in the machine to prevent accidents.
7. Use flammable materials near the machine and keep them away to prevent accidents.
8. Please be careful to put the items into the machine. Please wear high temperature gloves when the temperature is above 60 degrees.
9. When the timer (warm-to-time) is working, the AL light on the temperature control table lights up, indicating that the temperature has reached the set range and the machine starts to hold the temperature.
10. When the temperature is held, when the display temperature and the set temperature are overshoot or low, an automatic calculation is required.
11. The heaters in the machine should be inspected regularly to remove dust and other debris.
1. Check if the voltage is correct before use. Please use the voltage indicated on the machine to avoid electric overload and fire.
2. ※The motor running direction is normal. If there is gas in the air outlet, it is normal. (Applicable only to models with three-phase voltage 380V).
3. When the display temperature is different from the actual temperature (measured by the standard thermometer), the parts and internal parameters of the circuit board should not be adjusted at will. The company should be notified to send the staff to handle.
4. When the temperature changes during use, do not open the door at will.
5. Do not place the machine in a damp place or rinse it directly with water to prevent leakage.
6. It is forbidden to put alcohol or adhesive. . . Etc., flammable, volatile items in the machine to prevent accidents.
7. Use flammable materials near the machine and keep them away to prevent accidents.
8. Please be careful to put the items into the machine. Please wear high temperature gloves when the temperature is above 60 degrees.
9. When the timer (warm-to-time) is working, the AL light on the temperature control table lights up, indicating that the temperature has reached the set range and the machine starts to hold the temperature.
10. When the temperature is held, when the display temperature and the set temperature are overshoot or low, an automatic calculation is required.
11. The heaters in the machine should be inspected regularly to remove dust and other debris.
